Primers are low or zero VOC, APE free, solventless, and primers are used on a clean and virgin surface of plaster, concrete, stone, tiles, bricks. A thin coat of 0.1 mm is applied, primer travels into the pores to a few microns and then it curses, and it blocks the surface pores. It stops the water vapors transmission; their uses also cau
Primers are low or zero VOC, APE free, solventless, and primers are used on a clean and virgin surface of plaster, concrete, stone, tiles, bricks. A thin coat of 0.1 mm is applied, primer travels into the pores to a few microns and then it curses, and it blocks the surface pores. It stops the water vapors transmission; their uses also caused in the reduction of the required amount of the base coat. These primers could be silicone acrylics, epoxy, polyurethane water-based dispersions, TEVO 2010, TEVO 2028, TEVO MS-11, TEVP HPU-13HPW, respectively.
Polyurea is two pack system, and it comes aliphatic and aromatic. These are robust coating; it protects the surface and prevent the water leak. Aliphatic system has an open time 10-20 minutes once it is mixed it should be applied in 10-15 minutes. It dries and cure less than 45 minutes. The aromatic system has zero minutes open time, it
Polyurea is two pack system, and it comes aliphatic and aromatic. These are robust coating; it protects the surface and prevent the water leak. Aliphatic system has an open time 10-20 minutes once it is mixed it should be applied in 10-15 minutes. It dries and cure less than 45 minutes. The aromatic system has zero minutes open time, it never mixed, it only get mixed when it comes from two separate nozzles and mixed at a few seconds before it was sprayed is applied with a cartridge gun for a small size job and for extensive coating in a concrete pit, or a large size warehouse floor or for the insulation a two-pack pressure highly controlled and regulated machine is used.
Please reach us at if you cannot find an answer to your question.
We guide our customers on the surface preparation. We have a broad range of solventless and water-based epoxies, polyurea topskin and polyurethane water based dispersions.
Applications where one coat is needed and open time is needed and coating wanting to be ready to use and roll over, it is Tectevo TopSkin. The aromatic based polyurea is two pack system and we can't mix it before application, it is mixed in a small chamber and sprayed on the surface.
Tectevo helps customers surface preparation based on the surface condition, and it has decorative flooring coating, it also has fast curing and slow curing epoxies, solventless and water-based epoxies, and various colors. Our customers wanting broad and high-quality product in their hand and the high-quality technical surface.